<< Click to Display Table of Contents >> Navigation:  Getting started > Enter maintenance mode

When the software is running in normal patron mode, you can enter the Maintenance mode by touching the four corners of the screen in configured order. The default configuration is 1234 which means a ”U” shape: start by touching the top left corner first, then bottom left, then bottom right and last the top right corner. This should now enable the maintenance mode; if it doesn’t, please wait a few seconds before attempting again, so that the device will clear it’s internal buffer from the previous attempt.

The screen should look like this:

   

More information about Maintenance mode is available in section Maintenance mode.